Evaluation of 2D concentrically braced frames with cylindrical dampers subjected to near-field earthquake ground motions

Mirtaheri, M.; Salkhordeh, M.; S. Kolbadi, S. M.; Mirzaeefard, H.; Razzaghian, M. R.

doi:10.52547/nmce.4.3.21

Volume 4, Issue 3 (3-2020) NMCE 2020, 4(3): 21-30 | Back to browse issues page

‎ 10.52547/nmce.4.3.21

‎ 20.1001.1.23454296.2020.4.3.3.4

Mendeley

Zotero

RefWorks

Mirtaheri M, Salkhordeh M, S. Kolbadi S M, Mirzaeefard H, Razzaghian M R. Evaluation of 2D concentrically braced frames with cylindrical dampers subjected to near-field earthquake ground motions. NMCE 2020; 4 (3) :21-30
URL: http://nmce.kntu.ac.ir/article-1-265-en.html

Evaluation of 2D concentrically braced frames with cylindrical dampers subjected to near-field earthquake ground motions

M. Mirtaheri ^*¹, M. Salkhordeh², S. M. S. Kolbadi², H. Mirzaeefard², M. R. Razzaghian³

1- Associated professor, Department of Civil and Environmental Engineering, K. N. Toosi University of Technology, Tehran, Iran. , mmirtaheri@kntu.ac.ir
2- PhD student, Department of Civil and Environmental Engineering, K. N. Toosi University of Technology, Tehran, Iran.
3- Graduate student, Department of Civil and Environmental Engineering, K. N. Toosi University of Technology, Tehran, Iran.

Abstract: (905 Views)

Near field earthquakes have imposed major damage to buildings in the past years. In some cases, the intensity of such damage is too considerable to be disregarded. The most effective way to improve seismic performance of buildings is applying a seismic control technique. The cylindrical friction damper is one of these methods, which has become popular for its desirable performance in the energy dissipation of lateral loads. The main objective of this study is to evaluate the near-field seismic performance of braced frame buildings equipped with cylindrical friction dampers. In this regard, four steel braced frame buildings, including a 4-, 8-, 12-, and 16-story braced frame building are modeled in OpenSees platform. Then, a set of near-field earthquake motions are applied to these structures and the structural response is captured in each story. Results show that there is a direct relation between the optimal slip load and the intensity of the input earthquake. In the next step, the structures are analyzed by selecting the optimum slip load for the damper. It is revealed that cylindrical friction dampers improved structural performance in terms of energy absorption of the structure. However, findings confirm that there is an indirect relationship between the number of floors in a building and the above mentioned feature of these dampers.

Keywords: Steel structures Cylindrical friction dampers Near field earth quacks Incremental dynamic analysis.

Full-Text [PDF 1018 kb] (232 Downloads)

Type of Study: Research | Subject: Special
Received: 2020/01/20 | Revised: 2020/02/20 | Accepted: 2020/03/20

References

1. [1] Zafarani Hamid& Noorzd Asadollah & Bargi Khosro (2006) (Generation Of Near-Field Ground Motions In Tehran From Future Large Earthquake In The Alborz Seismic Zone) First European Conference on Earthquake Engineering and Seismology (a joint event of the 13th ECEE & 30th General Assembly of the ESC)Geneva, Switzerland.

2. [2] Khaloo Ali R. & Khosravi Horr (2006) (Studying Shear and Flexural Response of Buildings to Pulse like Ground Motion in Near-Field Earthquakes) First European Conference on Earthquake Engineering and Seismology (a joint event of the 13th ECEE & 30th General Assembly of the ESC) Geneva, Switzerland.

3. [3] Mirtaheri Masoud, Zandi Amir Peyman & Sharifi Samadi Sahand & Rahmani Samani Hamid (2010) "Numerical and experimental study of hysteretic behavior of cylindrical friction dampers" Journal of Engineering structure. [DOI:10.1016/j.engstruct.2011.07.029]

4. [4] S. Mazzoni, F. McKenna, M.H. Scott, G.L. Fenves, B. Jeremic. (2004) (OpenSees Command Language Manual).

5. [5] Pall AS, Marsh C. Response of friction damped braced frames. J Struct Eng 1982; 108(9):1313-23. [DOI:10.1061/JSDEAG.0005968]

6. [6] Wua B, Zhanga J, Williamsb MS, Oua J. Hysteretic behavior of improved Palltyped frictional dampers. Eng Struct 2005;27:1258-67. [DOI:10.1016/j.engstruct.2005.03.010]

7. [7] Aiken ID, Kelly JM. Earthquake simulator testing and analytical studies of two energy-absorbing systems for multistory structures. Report no. UCB/EERC90/03. Berkeley (CA): Earthquake Engineering Research Center. University of California; 1990.

8. [8] Nims DK. et al. Application of the energy dissipating restraint to buildings. In: Proc. ATC 17-1 on seismic isolation, energy dissipation, and active control. 1993. p. 627-38.

9. [9] Ahmad, N. and Masoudi, M., 2020. Eccentric steel brace retrofit for seismic upgrading of deficient reinforced concrete frames. Bulletin of Earthquake Engineering, pp.1-35. [DOI:10.1007/s10518-020-00808-0]

10. [10] Ahmad, N., Shakeel, H. and Masoudi, M., 2020. Design and development of low-cost HDRBs seismic isolation of structures. Bulletin of Earthquake Engineering, 18(3), pp.1107-1138. [DOI:10.1007/s10518-019-00742-w]

11. [11] Lavan, O. and Amir, O., 2014. Simultaneous topology and sizing optimization of viscous dampers in seismic retrofitting of 3D irregular frame structures. Earthquake engineering & structural dynamics, 43(9), pp.1325-1342. [DOI:10.1002/eqe.2399]

12. [12] BHRC (Building and Housing Research Center). 2004. Iranian Code of Practice for Seismic Resistant Design of Buildings. Standard No. 2800, 3rd edn. BHRC: Tehran.

13. [13] OpenSees.berkeley.edu(2006). Steel 01 Material. [OpenSees.berkeley.edu/OpenSees/manuals/comparisonManual/2770.htm]

14. [14] Masoudi, M. and Khajevand, S., 2020. Revisiting flexural overstrength in RC beam-and-slab floor systems for seismic design and evaluation. Bulletin of Earthquake Engineering, 18(11), pp.5309-5341. [DOI:10.1007/s10518-020-00907-y]

15. [15] Chopra A.K.(2000) , " Dynamics of Structure : Theory and Application to Earthquake Engineering" , Upper saddle river , NJ , (2nd Ed).

16. [16] Mirtaheri, M., Emami, F., Zoghi, M.A. and Salkhordeh, M., 2019. Mitigation of progressive collapse in steel structures using a new passive connection. Structural Engineering and Mechanics, 70(4), pp.381-394.

17. [17] Karami-Mohammadi, R., Mirtaheri, M., Salkhordeh, M. and Hariri-Ardebili, M.A., 2020. Vibration Anatomy and Damage Detection in Power Transmission Towers with Limited Sensors. Sensors, 20(6), p.1731. [DOI:10.3390/s20061731]

18. [18] Karami-Mohammadi, R., Mirtaheri, M., Salkhordeh, M., Mosaffa, E., Mahdavi, G. and Hariri-Ardebili, M.A., 2019. Seismic mitigation of substation cable connected equipment using friction pendulum systems. Structural Engineering and Mechanics, 72(6), pp.785-796.

19. [19] Rahmani Samani Hamid, Mirtaheri Masoud, Zandi Amir Peyman) June 2015 .(Experimental and numerical study of a new adjustable frictional damper. Journal of Constructional Steel Research. [DOI:10.1016/j.jcsr.2015.05.019]

20. [20] Mirzaeefard Hamid, Mirtaheri Masoud (1394). Evaluation of Seismic Behavior and Select Optimal Situation of Cylindrical Frictional Dampers in Steel Structures. Journal of structural and construction engineering.

21. [21] Mirtaheri, M. and Salkhordeh, M., 2018. A real-time recursive dynamic model for vehicle driving simulators. Journal of Numerical Methods in Civil Engineering, 3(2), pp.13-23. [DOI:10.29252/nmce.3.2.13]

22. [22] Samani, H.R. and Mirtaheri, M., 2016. Seismic response sensitivity of the structures equipped with cylindrical frictional dampers to the value of slippage load. Journal of Numerical Methods in Civil Engineering, 1(1), pp.57-63. [DOI:10.29252/nmce.1.1.57]

23. [23] Alavi, B. and Krawinkler, H., 2001. Effects of near-fault ground motions on frame structures (p. 301). Stanford: John A. Blume Earthquake Engineering Center.

24. [24] Fanaie, N., Sadegh Kolbadi, M. and Afsar Dizaj, E., 2017. Probabilistic Seismic Demand Assessment of Steel Moment Resisting Frames Isolated by LRB. Journal of Numerical Methods in Civil Engineering, 2(2), pp.52-62. [DOI:10.29252/nmce.2.2.52]

Send email to the article author

Rights and permissions